WatchGuard Add static route
To add routes for traffic through a branch office VPN tunnel, you add a tunnel route that specifies the local and remote IP addresses for the route. You can configure ... ,Static routes that you add to this list also appear in the static routes list for the device. In Fireware v12.4 or higher, you can configure IPv6 BOVPN virtual interface ...
| 相關軟體 Connectivity Fixer 資訊 | |
|---|---|
 WatchGuard Add static route 相關參考資料
Add a Static Route - WatchGuard Technologies
Select Network > Routes. The Setup Routes dialog box appears. Click Add. The Add Route dialog box appears. ... From the Route Type drop-down list, select Static ... https://www.watchguard.com Add Routes for a Tunnel - WatchGuard Technologies
To add routes for traffic through a branch office VPN tunnel, you add a tunnel route that specifies the local and remote IP addresses for the route. You can configure ... https://www.watchguard.com Configure VPN Routes - WatchGuard Technologies
Static routes that you add to this list also appear in the static routes list for the device. In Fireware v12.4 or higher, you can configure IPv6 BOVPN virtual interface ... https://www.watchguard.com Configuring a Static Route - WatchGuard Technologies
Configuring a Static Route. You can add a static route to the Firebox SSL so that it correctly routes packets that are not on the same subnet as the Firebox SSL. http://www.watchguard.com Read the Firebox Route Tables - WatchGuard Technologies
Routes the Firebox learns from dynamic routing processes running on the device (RIP, OSPF, and BGP); Permanent (static) network routes or host routes you add, ... https://www.watchguard.com Routes - WatchGuard Technologies
For both IPv4 and IPv6 routes, the available route types include static, dynamic, connected, and VPN. For each route, the Routes table includes this information:. https://www.watchguard.com Routes and Routing - WatchGuard Technologies
To update the route table at other times, you must use dynamic routing or add a static route. Static routes can improve performance, but if there is a change in the ... https://www.watchguard.com [SOLVED] How to setup a Static Route - WatchGuard
Solution: This should be defined in the tunnel route between both sites - instead just ... I am trying to figure out how to setup a static route on my Watchguard XTM ... https://community.spiceworks.c |