port channel down
Hi, Netapp server is connected to switch 6500 via trunk. I configured a portchannel but it showing as down.take a look ar below output..,Solved: I have setup an active LACP consisting of two members in each port-channel. As it is configured now the individual ports are operational but not ...
| 相關軟體 Cisco Packet Tracer 資訊 | |
|---|---|
 port channel down 相關參考資料
Etherchannel issue, Port-Channel down d... - Cisco Community
Etherchannel issue, Port-Channel down down but correctly configured. Hello everybody: I has a issue about etherchannel beetwen 02 Catalyst ... https://community.cisco.com Etherchannel showing down (SD) and port... - Cisco Community
Hi, Netapp server is connected to switch 6500 via trunk. I configured a portchannel but it showing as down.take a look ar below output.. https://community.cisco.com Solved: LACP port-channel down but Individual p... - Cisco Community
Solved: I have setup an active LACP consisting of two members in each port-channel. As it is configured now the individual ports are operational but not ... https://community.cisco.com Solved: Layer 2 "downdown" on Port channel aft... - Cisco Community
Layer 2 "down/down" on Port channel after issuing "speed 100" command on 3750E switches. Hello all! First discussion post here... I have two ... https://community.cisco.com Solved: Port channel issue - Cisco Community
I did the configuration but port channel still down , kindly check the below config:- 3850. interface Port-channel1 switchport mode trunk. inter gi1/0/1. switchport ... https://community.cisco.com Solved: port-channel issues - Cisco Community
Solved: Hi I set up a port-channel trunk between a acess switch 3750 ( int gi2/0/1 and ... when I do show etherchannel sum -it show the port-channel is down. https://community.cisco.com Troubleshooting Port Channels and Trunking - Cisco
Newly Added Interface Does Not Come Online In a Port Channel, page 7-4 ... If a link goes down in a port channel, the upper protocol is not aware of it. To the. https://www.cisco.com Why doesn't my port-channel interface come up, between Cisco ...
Improperly configured EtherChannel (port-channel) interfaces would be disabled automatically, to prevent problems such as loops. First of all ... https://networkengineering.sta 【Cisco】EtherChannel @ mini鵝的天地:: 痞客邦::
PAGP (Port Aggregation Protocol)－Cisco專有協議 ... #interface port-channel 1 ... 狀態 D-Down , P-正常 , I-Stand alone (一邊Down 一邊UP). http://a46087.pixnet.net 建立Port Channel(LACP&PAgP) - James LAB
Cisco EtherChannel主要有兩種協定可選擇，分別為PAgP(Port Aggregation Protocol)與LACP(Link ... Flags: D - down P - in port-channel. http://www.james-tw.com |