mkfs ext4
Because it is not possible to change either the bytes-per-inode ratio or the inode count after the filesystem is created, mkfs.ext4 uses by default a rather low ratio of one inode every 16384 bytes (16 KiB) to avoid this situation. However, for partition, If everything is OK, write the new partition table to the disk ( W ) and exit ( Q ). Now that you have your new, empty partition, you can create its filesystem. So, if you just created /dev/sdaX (where X is the number of the partition you created, for ex
| 相關軟體 USB Block 資訊 | |
|---|---|
 mkfs ext4 相關參考資料
Creating an ext4 file system - IBM
To create an ext4 file system, use the mkfs.ext4 command. In general, the default options are optimal for most usage scenarios: # mkfs.ext4 /dev/device. Below is a sample output of this command, which... https://www.ibm.com Ext4 - ArchWiki
Because it is not possible to change either the bytes-per-inode ratio or the inode count after the filesystem is created, mkfs.ext4 uses by default a rather low ratio of one inode every 16384 bytes (... https://wiki.archlinux.org linux - Creating ext4 partition from console - Super User
If everything is OK, write the new partition table to the disk ( W ) and exit ( Q ). Now that you have your new, empty partition, you can create its filesystem. So, if you just created /dev/sdaX (whe... https://superuser.com mke2fs - Ubuntu Manpage Repository
If mke2fs is run as mkfs.XXX (i.e., mkfs.ext2, mkfs.ext3, or mkfs.ext4) the option -t XXX is implied; so mkfs.ext3 will create a file system for use with ext3, mkfs.ext4 will create a file system for ... http://manpages.ubuntu.com |